Okay, so I was looking at my ugly fireplace and wonder, "What can I do to give this focal point more pizzazz without spending a fortune"? Well, I like the mantle and I could paint it, but I plan on moving from this home in a few years and someone else may not like a dark espresso mantle, so I decided to do something about the tile. The tile is 16 years old and obviously outdated. The problem was, how was I going to take that tile off without ruining the fireboard stuff underneath. I knew that I could not replace that myself, so I kept thinking. Then it occurred to me: glass mosaics are VERY trendy right now. The glass pieces are thinner than regular ceramic or porcelain and if you score the tile with sandpaper, mortar is designed to adhere, so that was my new mission. Then I remembered seeing some inexpensive mosaics at a local store in Houston called Floor and Decor. Everything is basically liquidated or classified as seconds, but you can get trendy stuff for half or more off the price. The cost per 12 x 12" mesh sheet of bronze/chocolate mosaics was only $8. I only needed approx. 8 sheets and then a small bag of thinset and grout. The great thing about the mosaic sheeting is that you can cut it, so shaping around your fireplace is a breeze.
My tiles are not really shiney, so not much sanding was needed. I then used a trowel to apply the thinset and worked from one corner toward the center. You will have to play with your tiles a bit, kinda like a puzzle to make sure you know how many tile pieces will fit and HOW they will fit best. I kept areas that had wider grout closest to the edge of the mantle where it is not noticeable. I continue for about 2 hours untile the fireplace surround and hearth was cover in mosaics. You have to allow this to set for approx. 48 hrs. Once set, you can mix your grout. You will need to purchase a special sponge with a handle from the hardware store. This allows you to push the grout into the cracks and wipe it clean over the top of the tiles so that you have even grouting. I was told (unfortunately afterward) that buying a grout release mixture to mix in with the grout, makes removing the grout on the tops of the tiles MUCH easier. So, once your grout has been successfully pressed into all your groves and wiped off as best as possible, you need to take a BIG large sponge and water and wipe off any excess grout residue before it hardens. This is where the grout release comes in handy. I did not use it and it took me FOREVER to get the tiles clean, but I did it. Here is the end result. I will show before, during and after pics :).

Don't forget to click on the pictures so see them up close and personal :).
ReplyDelete