Saturday, January 9, 2010

How to create a leather look on a wall!

Although color/paint on a wall is almost essential, after a while, solid paints can become boring. I like to accent one or two rooms with either texture or a finish that has more dimension and creating a leather-look on a wall is one way to do it. I suggest a bathroom or powder room because it is small and the finish won't become overwhelming. This job is a three step process and it time intensive, but the finished product is beautiful and high-end.

First you will need white tissue paper (the thicker, the easier to work with). You will also need a jug of prepasted wallpaper glue, your base coat (which shouldn't be a dark paint color - typically a lighter tan or khaki color, although it's your wall and the base color is up to you) and your glaze color. You can either have the glaze tinted at your local paint store, or you can buy your own quart of paint and mix equal parts clear glaze. You can also add small amounts of water to the mixture AFTER it has been prepared if you prefer to work with a thinner product (I like it because it goes on lighter and you can always apply more glaze in a second layer).

To prepare the walls you will need to tear the edges of most of your sheets of tissue and ball them up into balls. You can keep a few sheets aside for corners and edges (top and bottom) and tear only the sides that will move in toward the middle of the wall. This gives you the ability to place the edge of the sheet where you have not torn, tightly against the corner or edge for a finished look. You can also use an exacto knife to cut away paper if you prefer to just stick down and worry about rough edges later (with the exacto).

Take a roller and dip it into your pre-pasted wallpaper glue and roll onto wall in a 24" x 24" square (roughly the size of you tissue sheet). Shake out the tissue ball and apply onto the glue. You can add more wrinkles if you want more texture, but I prefer to just lay the sheet onto the wall with minimal creases. This helps prevent tearing later on down the road, especially if you have children or pets, but it is inevitably up to you. Be sure to overlap your sheets as you go. You can always tear off any clumping etc... Just tear off a smaller piece and cover over any boo-boos.


Once you have covered the entire wall area, you will need to let it dry overnight before you apply your base color.  Once the base color has dried, you can start applying your glaze. Using a large tile grout sponge (get them at Lowe's), you apply the glaze in large circles, being sure to blend away streaks and lines, otherwise it won't look well blended. You can always apply more glaze, but it is best to wait a little bit because the glaze will rub off and create patchy areas. Work on one or two more areas before you come back to add more glaze.

2 comments:

  1. Its a wonderful Blog. Home staging is no longer a luxury. Selling your home without home staging is just simply foolish.So Home Staging is necessary.

    ReplyDelete